Configuring rollup connection

1. From the Remote Asset Manager web page, click General > Rollup Configuration.

2. Configure the settings.

   • Host—The IP address or the Domain Name System of LFT 3

   • Port—The port used to connect to LFT 3

     Note: By default, SSL Secured is selected, and the port number is set to 443.

   • Enrollment Code

     Note: Generate the enrollment code from LFT 3. For more information, see the Lexmark Fleet Manager Administrator’s Guide.

   • Rollup Method

     • HTTP/HTTPS—Data is sent to the aggregation system such as LFT 3 or other server-based data aggregators. This method is the default. For more information on how to incorporate CA certificate for HTTPS protocol, contact your Lexmark representative.

     • Email—When enrolled, data is sent to the aggregation system.

     • Manual—Data is exported manually from the data collector, and then imported manually to the LFT 3.

   Note: To run a full collection of device counters, supply information, and statuses at enrollment, select Start a Full Collection Now.

3. Click Enroll.

Notes:

• If a Server Not Trusted error appears, then validate the information from the server, and then proceed to complete the enrollment.
• The enrollment code is unique for every enrollment. If you reenroll, then retrieve a new enrollment code from LFT 3.

Configuring proxy server settings

When a server is off-site, a proxy server may be required to connect to the server. For more information, contact your administrator.

1. From the Remote Asset Manager web page, click General > Proxy Configuration.

2. Configure the settings.

   • Proxy Host—The IP address or the Domain Name System of the proxy server

   • Proxy Port—The port used to connect to the proxy server

   • Username

   • Password

3. Click Save.