| Note: This procedure applies only to printer models that do not support adding, editing, or deleting destinations. |
From the Embedded Web Server, access the configuration page for the application.
Configure these settings:
Maximum File Size (KB)—Specify a value for maximum file size in kilobytes for e-mail attachments.
| Note: Each file contains at least one page. If any single page of a scanned document exceeds the maximum file size, then the scanned document is not sent. Increase the maximum file size or adjust the scan settings to send the document. |
Enable Multiple Attachments—Enable sending of multiple attachments in a single mail.
E-mail Subject—Specify the default subject of e-mails sent to the destination.
Attachment File Name—Specify the base file name for the documents that you are scanning.
Do one of the following:
Click Restore Defaults to restore all fields to factory default settings.
Click Reset to cancel changes to all fields and begin again.
Click Apply to save changes.
| Note: Reset and Apply are the only options available in some printer models. |