Cleaning the printer

  CAUTION—SHOCK HAZARD:  To avoid the risk of electrical shock when cleaning the exterior of the printer, unplug the power cord from the electrical outlet and disconnect all cables from the printer before proceeding.

Notes:

• Perform this task after every few months.
• Damage to the printer caused by improper handling is not covered by the printer warranty.

1. Turn off the printer, and then unplug the power cord from the electrical outlet.

2. Remove paper from the standard bin and multipurpose feeder.

3. Remove any dust, lint, and pieces of paper around the printer using a soft brush or vacuum.

4. Wipe the outside of the printer with a damp, soft, lint-free cloth.

   Notes:

   • Do not use household cleaners or detergents, as they may damage the finish of the printer.
   • Make sure that all areas of the printer are dry after cleaning.

5. Connect the power cord to the electrical outlet, and then turn on the printer.

     CAUTION—POTENTIAL INJURY:  To avoid the risk of fire or electrical shock, connect the power cord to an appropriately rated and properly grounded electrical outlet that is near the product and easily accessible.

Cleaning the scanner

1. Open the scanner cover.

   

2. Using a damp, soft, lint-free cloth, wipe the following areas:

   • ADF glass

     

   • ADF glass pad

     

   • Scanner glass

     

   • Scanner glass pad

     

3. Close the scanner cover.

Cleaning the printhead lens

1. Open door A.

2. Remove the waste toner bottle.

   

3. Using the printhead wiper, clean the printhead lens.

   

4. Insert the wiper back into place.

5. Insert the waste toner bottle, and then close the door.

   

Emptying the hole punch box

1. Open door H.

   

2. Remove, and then empty the hole punch box.

   

3. Insert the hole punch box.

   

4. Close the door.