Paper jam in door C

1. Open door C.

     CAUTION—HOT SURFACE:  The inside of the printer might be hot. To reduce the risk of injury from a hot component, allow the surface to cool before touching it.
   

   Notes:

   • Make sure that the door does not hit any cable attached to the printer.
   • If a 3000-sheet tray is installed, then slide the tray to the right to open the door.

2. Remove the jammed paper from any of the following locations.

   Note:  Make sure that all paper fragments are removed.

   • Fuser area

     

   • Below the fuser area

     

   • Duplex area

     

   • Above the duplex area

     

3. Open the standard trays, and then remove the jammed paper.

   Note:  Make sure that all paper fragments are removed.
   

4. Close the trays, and then close the door.