Adjusting Power Saver

Available settings range from 1–240 minutes. The factory default is 30 minutes.

To increase or decrease the number of minutes before the printer enters Power Saver mode, do one of the following:

Using the Embedded Web Server

  1. Type the printer IP address into the address field of your Web browser.

    Note: If you do not know the IP address of the printer, then print a network setup page and locate the IP address in the TCP/IP section.

  2. Click Settings, and then click General Settings.

  3. Click Timeouts.

  4. In the Power Saver box, increase or decrease the number of minutes you want the printer to wait before it enters Power Saver mode.

  5. Click Submit.

Using the printer control panel

  1. Make sure the printer is on and Ready appears.

  2. Press menu button.

  3. Press the arrow buttons until checkmarkSettings appears, and then press select button.

  4. Press the arrow buttons until checkmarkGeneral Settings appears, and then press select button.

  5. Press the arrow buttons until checkmarkTimeouts appears, and then press select button.

  6. Press the arrow buttons until picture of a checkmarkPower Saver appears, and then press select button.

  7. Press the arrow buttons to increase or decrease the number of minutes before the printer enters Power Saver mode, and then press select button.