Configuring the application

1. From the Embedded Web Server, access the configuration page for the application.

2. In the Site ID field, type the ID of the server that stores the reports.

3. In the Server Type menu, depending on your configuration, select either Web Service or LDD.

4. In the Server URL field, type either of the following:

   • http://hostname:9780/lmc

   • https://hostname/lmc

   Where hostname is the host name or IP address of the server.

5. Select Verify Certificate to validate all connections to the server. If Verify Certificate is not selected, then CA will not be validated.

   Note: This setting is applicable only when Server Type is set to SaaS or LDD.

6. In the Verification Mode menu, select either chain or peer.

   Note: The default value is chain.

7. Upload the server SSL certificate to connect securely to the server.

8. In the CheckHosts field, type the additional host names (other than the default server URL) to verify the entries in the certificate. Use commas to separate multiple host names.

   Note: By default, that white list contains just the server URL. Type additional host names in the CheckHosts field to include them in the white list.

9. Select the tracking settings.

10. If LDD is selected as the server type, then from the LDD Settings section, configure the settings.

    Note: If tracking is enabled and the server type is set to LDD, then the print job file size information is shown in the reports. This feature is available only in some printer models.

11. Click Apply.

Viewing reports

Before you begin, make sure that:

• For Lexmark Document Distributor version 4.0 or earlier, you have AdobeFlash Player version 10 or later. If your web browser settings do not allow ActiveX controls to run, then update the plug-in manually by visiting the Adobe website.

• Web browser cookies are enabled.

1. Open a web browser, and then type either of the following:

   • http://hostname:9780/lmc

   • https://hostname/lmc

   Where hostname is the host name or IP address of the server.

2. Log in as an administrator.

   Notes:

   • The default user name and password is admin.
   • If the Lexmark Management Console is configured to connect to an LDAP server, then use your LDAP user name and password.
   • Starting all services may take several minutes when the server is first booted. If the Lexmark Management Console cannot be accessed immediately after booting the system, then wait a few minutes, and then try again.

3. From the Lexmark Management Console, click the System tab.

4. From the System section, select Reports.

   Note: For more information on managing reports, see the Lexmark Print Management Administrator’s Guide.