Push the feeder release latch to the left to open the multipurpose feeder.
Grasp the extension, and pull it straight out until it is fully extended.
Prepare the paper for loading.
Flex sheets of paper back and forth to loosen them, and then fan them. Do not fold or crease the paper. Straighten the edges on a level surface.
Hold transparencies by the edges and fan them. Straighten the edges on a level surface.
Note: Avoid touching the print side of transparencies. Be careful not to scratch them. |
Flex a stack of envelopes back and forth to loosen them, and then fan them. Straighten the edges on a level surface.
Locate the stack height limiter and tab.
Note: Do not exceed the maximum stack height by forcing paper under the stack height limiter. |
1 | Tab |
2 | Stack height limiter |
3 | Width guides |
4 | Size indicators |
Load the paper, and then adjust the width guide to lightly touch the edge of the paper stack.
Load paper, card stock, and transparencies with the recommended print side facedown and the top edge entering first.
Load envelopes with the flap side up.
Warning—Potential Damage: Never use envelopes with stamps, clasps, snaps, windows, coated linings, or self-stick adhesives. These envelopes may severely damage the printer. |
Notes:
Make sure the paper is as far into the multipurpose feeder as it will go with very gentle pushing. Paper should lie flat in the multipurpose feeder. Make sure the paper fits loosely in the multipurpose feeder and is not bent or wrinkled.