The Universal Paper Size is a user-defined setting that lets you print on paper sizes that are not preset in the printer menus. Set the Paper Size for the Manual Feeder to Universal when the size you want is not available from the Paper Size menu. Then, specify all of the following Universal size settings for your paper:
Units of measure (inches or millimeters)
Portrait Height and Portrait Width
Feed Direction
| Note: The smallest supported Universal size is 76 x 127 mm (3 x 5 in.); the largest is 216 x 356 mm (8.5 x 14 in.). Paper that weighs at least 75 g/m2 (20 lb) is recommended for sizes less than or equal to 182 mm (7.17 in.) wide. |
Make sure the printer is on and appears.
From the printer control panel, press 
.
appears.
Press 
.
Press the arrow buttons until appears, and then press .
Press the arrow buttons until appears, and then press .
Press the arrow buttons until the correct unit of measure appears, and then press .
appears, followed by the menu.
Defining a specific height and width measurement for the Universal paper size (in the portrait orientation) allows the printer to support the size, including support for standard features such as duplex printing and printing multiple pages on one sheet.
| Note: Select to adjust the paper height setting or to adjust the paper width setting, or adjust both. Instructions to adjust both follow. |
From the Universal Setup menu, press the arrow buttons until appears, and then press .
Press the left arrow button to decrease the setting or the right arrow button to increase the setting, and then press .
appears, followed by the menu.
From the Universal Setup menu, press the arrow buttons until appears, and then press .
Press the left arrow button to decrease the setting or the right arrow button to increase the setting, and then press .
appears, followed by the menu.