These are possible solutions. Try one or more of the following:
Make sure
or appears on the display before sending a job to print.Remove the stack of paper from the standard exit bin.
Load paper in the tray.
Verify that you are using the correct printer software.
If you are using a USB port, make sure you are running a supported operating system and using compatible printer software.
Make sure the internal print server is properly installed and that the printer is connected to the network. For more information about installing a network printer, click View User's Guide and Documentation on the Software and Documentation CD.
Print a network setup page and check that the status shows Connected. If the status is Not Connected, check the network cables, and then try printing the network setup page again. Contact your system support person to make sure the network is functioning correctly.
Copies of the printer software are also available on the Lexmark Web site at www.lexmark.com.
For more information, visit the Lexmark Web site at www.lexmark.com.
Check the cable connections to the printer and print server to make sure they are secure.
For more information, see the setup documentation that came with the printer.
These are possible solutions. Try one or more of the following:
Reduce the number and size of fonts, the number and complexity of images, and the number of pages in the job.
From the printer control panel, press .
Press the arrow buttons until
appears, and then press .Press the arrow buttons until
appears, and then press .Press the arrow buttons until
appears, and then press .Press the arrow buttons until
appears, and then press .Press the arrow buttons until
appears, and then press .When using Eco-Mode or Quiet Mode settings, you may notice a short delay before the first page is printed. If you want to change the settings and need more information, then see Using Eco-Mode or Reducing printer noise.
Load the same size and type of paper in each tray.
Move the paper guides to the correct positions for the paper size loaded in each tray.
Print a menu settings page and compare the settings for each tray.
If necessary, adjust the settings from the Paper Size/Type menu.
Note: None of the paper sources, trays, or feeders automatically sense the paper size. You must set the size from the Paper Size/Type menu on the printer control panel or from the Embedded Web Server. |
These are possible solutions. Try one or more of the following:
From Print Properties or the printer control panel Finishing menu, set Collate to On.
Note: Setting Collate to Off in the software overrides the setting in the Finishing menu. |
Reduce the complexity of the print job by reducing the number and size of fonts, the number and complexity of images, and the number of pages in the job.
Increase the Print Timeout value:
From the printer control panel, press .
Press the arrow buttons until
appears, and then press .Press the arrow buttons until
appears, and then press .Press the arrow buttons until
appears, and then press .Press the arrow buttons until
appears, and then press .Press the arrow buttons until the value you want appears, and then press .