Setting up serial printing

In serial printing, data is transferred one bit at a time. Although serial printing is usually slower than parallel printing, it is the preferred option when there is a great deal of distance between the printer and computer or when an interface with a better transfer rate is not available.

After installing the serial port, you will need to configure the printer and the computer so they can communicate. Make sure you have connected the serial cable to the serial port on your printer.

1. Set the parameters in the printer:

   1. From the printer control panel, navigate to the menu with port settings.

   2. Locate the submenu with serial port settings.

   3. Make any necessary changes to the serial settings.

   4. Save the new settings.

   5. Print a menu settings page.

2. Install the printer driver:

   1. Insert the Software and Documentation CD. It launches automatically.

      If the CD does not launch automatically, then do the following:

      1. Click , or click Start and then click Run.

      2. In the Start Search or Run box, type D:\setup.exe, where D is the letter of your CD or DVD drive.

   2. Click Install Printer and Software.

   3. Click Agree to accept the Printer Software License Agreement.

   4. Click Custom.

   5. Make sure Select Components is selected, and then click Next.

   6. Make sure Local is selected, and then click Next.

   7. Select the manufacturer of the printer from the menu.

   8. Select the printer model from the menu, and then click Add Printer.

   9. Click the + beside the printer model under Select Components.

   10. Make sure the correct port is available under Select Components. This is the port where the serial cable attaches to the computer. If the correct port is not available, select the port under the Select Port menu, and then click Add Port.

   11. Make any configuration changes necessary in the Add a New Port window. Click Add Port to finish adding the port.

   12. Make sure the box next to the selected printer model is checked.

   13. Select any other optional software you want to install, and then click Next.

   14. Click Finish to complete the printer software installation.

3. Set the COM port parameters:

   After the printer driver is installed, you must set the serial parameters in the communications (COM) port assigned to the printer driver.

   The serial parameters in the COM port must match the serial parameters you set in the printer.

   1. Open the Device Manager.

      1. Click , or click Start and then click Run.

      2. In the Start Search or Run box, type devmgmt.msc.

      3. Press Enter, or click OK.

         The Device Manager opens.

   2. Click + to expand the list of available ports.

   3. Select the communications port where you attached the serial cable to your computer (example: COM1).

   4. Click Properties.

   5. On the Port Settings tab, set the serial parameters to the same serial parameters in the printer.

      Look for the printer settings under the serial heading on the Menu Settings page you printed earlier.

   6. Click OK, and then close all the windows.

   7. Print a test page to verify printer installation. When a test page prints successfully, printer setup is complete.